The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver. With powerful EX1002 KV20000 motors, and Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.
FC SPECIFICATIONS:
- SPI ELRS version Firmware target: CrazybeeF4SX1280
- SPI FRSKY version Firmware target: CrazybeeF4FR
- MCU: STM32F411CEU6 (100MHz, 512K FLASH)
- Sensor: ICM42688P
- Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
- Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
- Built-in Betaflight OSD(SPI Control)
- Built-in SPI Frsky/ExpressLRS receiver
- Built-in 5V 1A BEC
- Built-in voltage detection
4-IN-1 ESC SPECIFICATIONS:
- MCU upgraded to EFM8BB21
- Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
- Currents: 5A continuous peak 6A (5 seconds)
- Support BLHeliSuite programmable
- Factory firmware: O_H_5_REV16_8.HEX
- Default protocol: DSHOT150/DSHOT300/DSHOT600
ELRS SPI RECEIVER SPECIFICATIONS:
- Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
- RF Frequency: 2.4GHz
- Telemetry output Power: <12dBm
- Receiver protocol: SPI ExpressLRS
- Could bind with ELRS V2.0 firmware TX module
FRSKY SPI RECEIVER SPECIFICATIONS:
- SPI BUS receiver Frsky D8/D16 compatible
- Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
- Channels: 8ch or 16ch
- Failsafe support
- No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
- Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol
MOTOR SPECIFICATIONS:
- Model: EX1002 20000KV
- Configuration: 9N12P
- Stator Diameter: 10mm
- Stator Length: 2mm
- Shaft Diameter: Φ1.5mm
- Motor Dimension(Dia.*Len): Φ13.5mm*12.5mm
- Weight(g): 2.5g
- No. of Cells(Lipo): 1S only
GEMFAN 1610-2 PROPELLER SPECIFICATIONS:
- Weight: 0.24g
- Material: PC
- Pitch: 1 inch
- Props Dia: 40mm
- Center Hole Dia: 1.5mm
HDZERO NANO LITE CAMERA SPECIFICATIONS:
- Dimensions: 14x16x11 mm
- Weight: 1.5gram
- Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMos sensor
- Excellent low light performance
- FOV:
4:3: D:130° H:108° v:84°
16:9:D:122° H:108° V:65°
HDZERO WHOOP LITE VTX SPECIFICATIONS:
- 1S Input
- 25mW/200mW RF Output-SmartAudio Support
- 25.5×25.5 M2 Soft Mounting- Antenna Retention
- Removable Shielding Box- 32.5×32.5mm(29x29mm inner)
- 4.5grams/4mm Thickness (without shielding)
PACKAGE INCLUDES:
- 1 x Happymodel Moblite7 HDZero 1S 75mm Brushless HD FPV Whoop Drone – Chosen Receiver
- 1 x Moblite7 Spare Canopy
- 1 x Gemfan 1610 propeller Set (4cw+4ccw)
- 1 x Propeller disassemble tool
- 1 x Screwdriver
